You are currently visiting our USA site but have your version set to be UK. Would you like to visit our UK site instead?

You are currently visiting our UK site but have your version set to be USA. Would you like to visit our USA site instead?

Gate Gas Springs & Struts

Ask A Question

This stock range of gas spring has been specifically designed to meet the design requirements of a closing gate or door, but can be applied to other similar applications.

  • 316 stainless rod
  • Steel protective shroud
  • Fully damped in extension
  • Fitted with release valve so force can be reduced
  • Supplied with a combination of alternative end fittings

Fully damped in extension, IGS standard gate gas springs are a suitable alternative to standard gate closers and allow a much greater choice of mounting positions. These gas springs are using IGS standard design for outdoors gas springs and have been specifically designed to withstand over 100,000 cycles outdoors or indoors.

These gas springs are heavily damped in extension, ensuring that the closing movement of the gate is slow and cannot hurt or injure the person standing next to it (gas spring's force may need to be adjusted to obtain optimal speed/force).

Please note that whilst there is no damping in compression, gate gas springs are self-powered and are producing a high force regardless of the direction of the movement, please check this page for further information.

When you try to close a gate with your hand, you need to exert a force on the gate. This force (in Newtons) times the distance between your hand and the hinge (in metres) gives you the "manual closing torque" required to close the gate.

Other sizes including a fully stainless steel version can be manufactured against your specification.

If you realise that the gas spring is too strong you can reduce the force using the internal ball valve. Before you do so, please note that the minimum working force for this gas springs is 100 newtons. If you reduce the force below 100 newtons (about 10kg), the gas spring's life may be shortened.

Gate gas spring Part number

Description

F100113/BB/0100

150mm stroke gate gas spring/gate closer
Metal protective shroud - Stainless steel 316 rod.
Force: 100 up to 500 newtons 
 Product Datasheet
 Application Example 101

F100600/BB/0100

250mm stroke gate gas spring/gate closer 
Metal protective shroud - Stainless steel 316 rod.
Force: 100 up to 300 newtons
 Product Datasheet
 Application Example 1
 Application Example 2 
 Application Example 3 
 Application Example 5 
 Application Example 6 (when there's only a 5mm gap behind the gate)
 Application Example 7 (when there's 40mm gap or you can make a slot at least 32mm deep behind the gate)
 Application Example 9 (with an opening of 111 degrees)

Example of a gas spring F100600/BB/0100 fitted on an access wooden door.

The gate gas spring in the video below is fitted as per Application Example 7.

On this video, when the door is fully open, the gap behind the door goes from 20mm at the hinge, up to 70mm at the door handle.

The fixed point is 150mm away from the centre of the hinge and the door point is 693mm away from the centre of the hinge.


By submitting this form, I accept the data Privacy Policy.

Have A Question?

Please submit an inquiry and we will be in touch soon!